| Preon I HAIII Black-S2 Edition
-
LED: CREE XP-G S2
- Max Output: 60 ANSI Lumens
- Material: Aircraft Grade Aluminum-Hard Anodized Black
- Lens: Optical-grade glass lens with anti-reflective coating on both sides
- Water resistance: IPX-8
- Battery: One AAA, included (see voltage range to select acceptable batteries for this light)
- Operating Voltage Range: 0.9V-3.0V
- Seven Output Modes:
Low: 2 OTF Lumens, 23 hours
Medium: 13 OTF Lumens, 6 hours
High: 60 ANSI Lumens, 37 minutes
Strobe 1.6 hours
SOS 2.4 hours
Beacon (Hi) 8 hours
Beacon (Lo) 40 hours
- Dimensions:
Length: 2.95 inches
Diameter: 0.55 inches
Weight: 0.6 ounces
Included Accessories
- Removable clip
- Ring for keychain attachment
Operation
Operating your Preon 1 is simple. Make sure its batteries are inserted with the positive side (+) toward the head. Ensure the tailcap is tightened. To turn the Preon on, tighten the bezel (the ‘head’ of the light) fully down. The Preon will turn on when the bezel is fully tightened, and turn off when the bezel is loosened.
Selecting Regular Outputs
To select a different level of constant output, turn the Preon off and then on again within 1 second. This will select the next level of constant output in the following sequence:
Low -> Medium -> High
If the Preon is turned off for 2 seconds or longer, it will revert back to Low.
Selecting Special Outputs
The Preon has 4 special output modes: Strobe, S.O.S., Beacon (Hi), and Beacon (Lo). To access these modes, quickly switch through two full 'cycles' of the regular outputs, starting with Low. These two full cycles must be completed within 3 seconds:
Low -> Medium -> High -> Low -> Medium -> High -> Special Outputs
You can continue to cycle through the special outputs in the following sequence:
Strobe -> S.O.S. -> Beacon (high) -> Beacon (low)
After Beacon (Lo) mode, the output reverts back to Regular Low. Both Beacon modes will first flash 5 times and then once every 10 seconds. |
