Shopping Bag

0 item(s) in cart/ total: $0    view cart
EDC Bezel

EDC Bezel

review
0
0
5
Your Price: $23.00
In Stock
Part Number:725

Choose Options

Finish
EDC Stainless Steel Bezel

Fits EDC Clicky and Rotary lights

The bezel has crenelations around the top edge for self defense and to allow light to escape when the flashlight is turned bezel down on a table.
High strength ACME threads.

Choose from lightly polished silver SS or Black coated.

The black bezel is made from stainless steel with a military black AlTiN (aluminum titanium nitride) finish. The AlTiN finish is super durable. AlTiN is the same finish used to coat machine tools to make them last longer.

Installation Instructions:
  • *Do not touch the reflective surface of the reflector* - the reflective surface cannot be cleaned - touching the reflective surface will damage it. * Do not touch the LED* - touching the LED will damage it.
  • Unscrew the head from the battery compartment. Set the battery compartment aside.
  • The reflector holds the bezel and head together. When you unscrew the bezel from the head, the reflector normally stays with the bezel. However, sometimes the reflector will stay with the head. The procedure changes depending on which circumstance happens.
  • If Reflector stays with the head. Put the head on the table reflector up. Tap the lens gently with your finger nail so it is sitting on the reflector. Keeping the head on the table, continue unscrewing the bezel, taping the lens every half turn or so. When the bezel is free, carefully lift it straight up. You should be left with the head, reflector, the lower O-ring, the glass lens and possibly the upper O-ring in the stack.
  • If Reflector stays with the bezel. Set the head aside, LED side up. Using a strap wrench, unscrew the reflector from the bezel until the O-ring is exposed and stop there - you should now be able to use your fingers to finish unscrewing the reflector. Put the bezel/reflector assembly bezel up on the table - i.e., it will be sitting on the flat end of the reflector. Tap the lens gently with your finger nail so it is sitting on the reflector. Keeping the reflector on the table, continue unscrewing the bezel, taping the lens every half turn or so. When the bezel is free, carefully lift it straight up. You should be left with the reflector, the lower O-ring, the glass lens and possibly the upper O-ring in the stack.
  • If the upper O-ring is not on the lens, carefully remove it from the bezel and set it on the lens directly above the lower O-ring.
  • Carefully place the new bezel over the stack and screw it down. Ensure that the O-rings sit in their little grooves and do not come out and get pinched. If the reflector stayed with the bezel during dis-assembly, lift the stack off the table keeping it in the same orientation and place it on the head and screw the reflector into the head. Tighten everything by grabbing the bezel and head. You only need to tighten until the gaps between the bezel, reflector and head are gone - do not over tighten.


Related Items

Recently Viewed Items