Titanium Preon I Satin

Preon 1 Specifications

• LED: CREE XP-G R5
• Max Output: 70 Out-the-front (OTF) lumens
• Material: Satin Titanium
• Lens: Optical-grade glass lens with anti-reflective coating on both sides
• Reflector: Light orange-peel textured
• Battery: One AAA, included (see voltage range to select acceptable batteries for this light)
• Operating Voltage Range: 0.9V-3.0V
• Seven Output Modes:

  Low: 1.8 OTFLumens, 23 hours
  Medium: 8.5 OTFLumens, 6 hours
  High: 70 OTFLumens, 0.8 hours
  Strobe 1.6 hours
  SOS 2.4 hours
  Beacon (Hi) 8 hours
  Beacon (Lo) 40 hours
  

• Dimensions:

  Length: 2.95 inches
  Diameter: 0.55 inches
  Weight: 0.6 ounces

• Waterproof: IPX-8 Rating

Included Accessories

• Removable silver stainless steel clip
• O-ring
• Split-ring for keychain attachment
• One AAA battery

Operation

Operating your Preon 1 is simple. Make sure its batteries are inserted with the positive side (+) toward the head. Ensure the tailcap is tightened. To turn the Preon on, tighten the bezel (the ‘head’ of the light) fully down. The Preon will turn on when the bezel is fully tightened, and turn off when the bezel is loosened.

Selecting Regular Outputs

To select a different level of constant output, turn the Preon off and then on again within 1 second. This will select the next level of constant output in the following sequence:

If the Preon is turned off for 2 seconds or longer, it will revert back to Low.

Selecting Special Outputs

The Preon has 4 special output modes: Strobe, S.O.S., Beacon (Hi), and Beacon (Lo). To access these modes, quickly switch through two full 'cycles' of the regular outputs, starting with Low. These two full cycles must be completed within 3 seconds:

You can continue to cycle through the special outputs in the following sequence:

After Beacon (Lo) mode, the output reverts back to Regular Low. Both Beacon modes will first flash 5 times and then once every 10 seconds.